| Author |
Message |
 Topic: WTB- 74 GT80 parts |
sesshomaru
Replies: 5
Views: 808
|
 Forum: Wanted Ads Posted: Mon Jun 28, 2010 12:43 am Subject: WTB- 74 GT80 parts |
| I believe he is talking about the Yamaha GT80. Hard to tell though as he didn't put the manufacturer. |
| Topic: Yamaha CT1/CT2 |
sesshomaru
Replies: 2
Views: 760
|
Forum: Yamaha Posted: Sun Jun 27, 2010 2:28 pm Subject: Yamaha CT1/CT2 |
| You may want to ask the guys over at yamahaenduro.com |
| Topic: Freezing tanks to remove dents |
sesshomaru
Replies: 9
Views: 1710
|
Forum: Yamaha Posted: Sun Jun 27, 2010 2:28 pm Subject: Freezing tanks to remove dents |
| Don't do this, you will ruin the tank. Sometimes they bloat, other times they split at the seams...never heard a happy ending with this procedure. |
| Topic: '72 CS3 Engine Help! |
sesshomaru
Replies: 3
Views: 783
|
Forum: Yamaha Posted: Thu Jun 24, 2010 8:57 pm Subject: '72 CS3 Engine Help! |
You definitely need seals. My RD400 was so bad it took forever to start and I had a 1/2 inch of burnt tranny oil and gas sitting in the crankcase.
HVC cycle should have the seals you need. |
| Topic: How to replace outer crankshaft seals on T500? |
sesshomaru
Replies: 19
Views: 2168
|
Forum: Suzuki Posted: Fri Jun 11, 2010 9:23 am Subject: How to replace outer crankshaft seals on T500? |
| When I tore down my RD motors, I took a folded up rag and jammed it in between the primary drive gear and clutch. A penny works as well. Make sure you use a breaker bar when you do this...makes things ... |
| Topic: YDE3 |
sesshomaru
Replies: 29
Views: 5152
|
Forum: Yamaha Posted: Mon Jun 07, 2010 11:25 am Subject: YDE3 |
I think you should leave it stock unless the original pieces are so beat up that they are unusable.  |
| Topic: battery weakness after a bit of riding? |
sesshomaru
Replies: 4
Views: 802
|
Forum: Suzuki Posted: Wed Jun 02, 2010 5:15 pm Subject: battery weakness after a bit of riding? |
| It sounds like there's a problem with your charging coil or rectifier. |
| Topic: Is this a YR1 |
sesshomaru
Replies: 13
Views: 2158
|
Forum: Yamaha Posted: Wed Jun 02, 2010 9:06 am Subject: Is this a YR1 |
| You may want to spray some penetrating fluid down the cylinder with low compression and kick it over a few times as it may be stuck rings, especially if it's been sitting. |
| Topic: Ignitoin Coils |
sesshomaru
Replies: 7
Views: 1233
|
Forum: Honda Posted: Tue Jun 01, 2010 8:26 pm Subject: Re: Ignitoin Coils |
I touch the leads to the pos and neg terminals and I get a reading of 5.5 with the dial set to "200".
I touch the leads to the metal spike inside the spark plug wire hole on the coil (n ... |
| Topic: Barn Find 1962 Suzuki 150/S32 |
sesshomaru
Replies: 31
Views: 4687
|
Forum: Suzuki Posted: Tue Jun 01, 2010 5:42 pm Subject: Re: Advice |
I have a 1968 Suzuki 150 S32-2 w/2K miles on it I would like to sell. Do you know what it's worth?
It's worth what someone would pay for it.  |
| Topic: YDE3 |
sesshomaru
Replies: 29
Views: 5152
|
Forum: Yamaha Posted: Wed May 19, 2010 6:02 pm Subject: YDE3 |
Here you go. The images are a large size so they are easier to read.
http://p1.bikepics.com/pics/2010%5C05%5C19%5Cbikepics-1978981-full.jpg
http://p1.bikepics.com/pics/2010%5C05%5C19%5Cbikepics-1 ... |
| Topic: YDE3 |
sesshomaru
Replies: 29
Views: 5152
|
Forum: Yamaha Posted: Tue May 18, 2010 8:29 am Subject: YDE3 |
is there any kind of manual on this bike?...i dont know much about it and without direct instruction im just gonna mess it up more than it already is.
I have some info for doing a basic tune-up. I' ... |
| Topic: YDE3 |
sesshomaru
Replies: 29
Views: 5152
|
Forum: Yamaha Posted: Mon May 17, 2010 9:51 pm Subject: YDE3 |
| latest update...the bike is finally running, however not running well. i got it started after cleaning the carbs, changing the plugs and such. it idles without any help now, which to my knowledge is a ... |
| Topic: yds3 engine problem |
sesshomaru
Replies: 4
Views: 1101
|
Forum: Yamaha Posted: Thu May 13, 2010 9:59 am Subject: yds3 engine problem |
| Either your rings are sticking in the left cylinder, it needs new rings or an oversize+rebore. |
| Topic: yds3 engine problem |
sesshomaru
Replies: 4
Views: 1101
|
Forum: Yamaha Posted: Thu May 13, 2010 8:57 am Subject: yds3 engine problem |
Did you store the bike properly?
Have you tried starting it with the choke left on?
New spark plugs?
Sure all connections are tight?
Check if you have spark?
Check that points are clean with g ... |
| |
