Search found 31 matches

I went out to the shop to count the links and teeth on my '71 CT70-H model. It has a 45 tooth rear sprocket. I believe it is all original but have been fooled before. I didn't check the front sprocket ...

I recently bought a new drive chain for my 1970 ct70H but it seems to be to short. The old rusty chain that was on there is a 420M 46 link and the new one is a 420M 44 link. The sprocket has 45 teeth ...

I recently rebuilt the top end on my k6 cb175 with new valves, seals and springs because the left cylinder was becoming oil fouled. Now that it is all back together it seemed to be running good until ...

I slowly tapped those "rings" off of a customer's CB175 forks with a mallot and a large regular {flat blade} screwdriver.
It took a long time but, I did it without screwing up the edges.
...

Hi
I am trying to replace the oil seals on my cb350's front forks. I have the forks off the bike and apart but can't not remove the chrome trim ring that surrounds the oil seal. I think it is pressed ...

I have been able to but a phillips bit on my torque wrench with a couple of adapters.

I figured they just needed to be good and tight like you said.

Thanks

My clymers manual only has torque specs for the cam cover nuts. It doesn't say anything about the left crankcase cover screws or the upper left and right cam cover screws. Do these screws need to be t ...

I just ordered a bunch of these valve parts from western hills honda and they did not have #17 the valve spring seal B. Is it ok to reuse the old part or do I need to find a new one. It's just a washe ...

its a cb175. How about the gaskets for the left crankcase cover, the cylinder base gasket, the cylinder head cover gasket, and left and right round cylinder head side covers? So basically the whole to ...

great thanks for the info guys.

I don't know if i should ask this but what is the general opinion on using gasket sealer or installing them dry?

I know the top two piston rings have markings which need to be facing up when installing them. How about the three piece oil ring? I didn't see any markings on the old ones so does it matter which way ...

Is there a way to tell if my cylinders have been bored out to a bigger size? The piston says "50" on the top of it so does that mean it has been bored out 0.50 over STD? The rings also have ...

ya that would be it. I was looking again at western hills honda and they did have it. I just didn't scroll down far enough. Thanks anyways.

I am looking for the "rubber stem seal" for a cb175K6, labeled #11 on the parts diagram and cmsnl part # 14733230000. It is not available from bike bandits or cmsnl.com or westerhillshonda. ...

ok I finally got around to buying some new float valve and seats along with a whole carb kit for both cylinders. I installed them and set the float height, idle mix and idle speed and fired it up. It ...